What Is That? Check Engine Light Service at Jones Automotive
Posted December 10, 2018 09:04 AM
Okay. You went to your local Belton car wash, and while your vehicle was under the dryer, the Check Engine light started flashing. Panic! What did you just do? Something is seriously wrong with the vehicle! You head for the nearest Belton service center, but on the way, the Check Engine light stops flashing and just glows red. Hmm. Maybe things aren't as bad as they seem. You decide to wait until payday to take your vehicle in to get serviced. In the meantime, the Check Engine light goes off. What? You decide the light must be faulty; maybe when it comes on it doesn't mean anything, or maybe it's just in your vehicle as some sort of scam to get you to pay for unnecessary repairs. You're glad you didn't take your car to the Belton repair shop and resolve to ignore that Check Engine light in the future.
Whoa! Let's look at what really happened. Your vehicle was under an air dryer. Your air intake sensor measured too much air running through the engine. It sent its report to the engine computer, where a warning was triggered; there shouldn't be that much airflow when the vehicle engine is idling. This is a serious problem that could cause permanent engine damage. Warning! The Check Engine light starts flashing, letting you know you need to take immediate action to prevent that damage.
You drive out from under the dryer, and the air intake sensor sends a new message to the computer. The computer realizes that everything is normal and tells the Check Engine light to stop flashing. The vehicle doesn't need immediate attention; but there was a problem, and it should be checked out by your Jones Automotive service advisor. After a few days the computer senses that the problem is gone, so it turns off the warning light.
You may think this story illustrates the uselessness of a Check Engine light, but you should remember that a computer can't think for itself; it can only follow its programming. It doesn't know the difference between a car wash air dryer and a serious malfunction in your vehicle engine. That doesn't make it useless. It just means you have to be the smart one.
Being smart doesn't mean ignoring your vehicle Check Engine light. It lets you know when something is wrong, and you can prevent a lot of damage to your vehicle by paying proper attention to it.
Your engine computer is constantly collecting data about what is going on inside your vehicle engine. It knows what parameters are normal and when a reading may indicate a problem. It uses the Check Engine light to let you know when something isn't right. It then stores a code in its memory — which a technician can retrieve — that indicates which reading was abnormal.
The technician uses this code as a starting place to find out what's wrong with your vehicle. It's like going to the doctor with a fever. The fever is the reading that is abnormal — your temperature is too high — but the doctor still has to figure out what's causing it. It's probably an infection, but what kind? Sinus infection? Appendicitis? Flu? The problems and their solutions are quite different. But a fever also tells a doctor what's NOT wrong with you. Fevers don't accompany stress headaches, ulcers or arthritis, so there's no sense in testing for those conditions.
The pros at Jones Automotive respond to a trouble code in your vehicle's computer in the same way. The code doesn't say exactly what's wrong, but it does give the technician a good indication of where to start looking —and where he/she doesn't need to look.
Now, you wouldn't consider diagnosing yourself with a serious medical problem — good medical advice unless you're a doctor. So you shouldn't consider trying to diagnose your vehicle's troubles by yourself — good auto advice unless you're a trained mechanic.
There are cheap scanners available on the market, and some Belton auto parts stores offer to read trouble codes from your vehicle engine's computer for you. But these are really not good alternatives to taking your vehicle to a qualified service center such as Jones Automotive in Belton. Your engine's computer has both short-term and long-term memory, and there are some codes that are specific to a particular make of vehicle. Cheap scanners can't read an engine computer's long-term memory nor can they interpret manufacturer-specific codes. That's why our manager at Jones Automotive spends a lot of money on high-end diagnostic tools.
It's as if you had a choice between a doctor who had a tongue depressor and a thermometer and one who had all the latest medical diagnostic equipment on hand. Honestly, which would you choose?
Getting your codes read at your Belton area auto parts store isn't really a money-saver, either, unless you're a trained mechanic. You'll end up with a code that tells you a symptom. What usually happens next is that the Belton area parts store sells you something that directly relates to the symptom. It may or may not fix the problem. It's actually cheaper to just go to Jones Automotive and get things fixed right the first time.
Remember, a fever can indicate a sinus infection or appendicitis. An antibiotic may be okay for that sinus infection, but it likely won't help your appendicitis. Is it really wise to wait around to see if the antibiotic helps when you might have appendicitis?
Part of good vehicle care is knowing where you can get a problem fixed — and fixed right. Preventive maintenance goes a long way to keeping you out of the repair shop, but eventually, we will all have a problem that needs fixing. Let's do it right the first time at Jones Automotive.
Diagnosing Your Vehicle at Jones Automotive in Belton
Posted January 16, 2017 01:35 AM
When we Belton residents get a car repair bill, we really shouldn't be surprised to find “diagnostic fees” as one of the line items. When we get a computer fixed, there is usually a charge for the time it takes to diagnose the problem. When we go to a medical doctor, most of his fee is for his ability to diagnose what's wrong. It's no different with our vehicles.
Some diagnoses are fairly simple. Brake repairs at Jones Automotive usually require only a visual inspection, for instance. But other problems are much more difficult to diagnose. An intermittent engine problem, for example, takes time and expertise to pinpoint.
Modern vehicles have multiple computers that monitor a variety of sensors throughout the vehicle. When one of those sensors has a reading that is higher or lower than the standard parameters, the computer turns on the Check Engine light. Technicians at a service center such as Jones Automotive in Belton can scan the engine's computer for a trouble code. This code tells the technician which reading is too high or too low.
That's where some Belton residents get confused. They think that this reading concludes the diagnosis, and they don't understand why the diagnostic fee is as much as it is when all the technician did was to scan the computer. But the truth is the trouble code is only the beginning of the diagnostic procedure.
Remember, the trouble code only tells which reading is out of parameter. It doesn't say what is causing the reading to be too high or too low. Your Jones Automotive service technician still has to find the underlying problem. It's a lot like going to the doctor. He can take your temperature and discover that you have a fever, but that doesn't tell him what is causing your fever.
Automotive diagnostic technology can cut down the time it takes to figure out what's wrong with a vehicle that isn't running right. But it doesn't do away with the need for your friendly and knowledgeable Jones Automotive service technician to make a proper diagnosis. Car care, like medical care, still requires the human touch.
The Jones Automotive Guide to Vehicle Diagnosis
Posted November 20, 2015 12:00 PM
Modern Belton vehicles have several computers on board that control all kinds of things like engine functions, transmission shifts, traction control, anti-lock brakes, stability control, emissions – and on some vehicles, even steering, braking and the throttle.
Think about that for a minute – things that used to be controlled by simple mechanical connections now have electronic controls that rely on computers, software and sensors. It's no wonder that when something goes wrong with their vehicle it can be pretty complicated for Belton drivers to track down the source of the problem.
To help your service advisor at Jones Automotive figure out what's wrong, your vehicle is equipped with on-board diagnostics. The Check Engine light comes on to tell you there's a problem and the engine management computer stores a trouble code. Your friendly and knowledgeable Jones Automotive technician connects a scan tool to your vehicle's diagnostic port and retrieves the trouble codes as well as other important data.
Trouble codes are like clues for the technician to follow as he diagnoses what's wrong with your vehicle. In a way, it's like going to your Belton doctor with a problem. She'll run some additional tests and gather the information she needs to make a diagnosis and form a treatment plan. How much a vehicle diagnosis costs at Jones Automotive in Belton depends on how much time it takes to sort out the symptoms and find the underlying problem.
Give us a call.
103 N Main Street
Belton, Texas 76513
Automotive Detective Work in Belton
Posted June 24, 2014 12:00 PM
There's a reason we use the word “diagnose” when we talk about fixing cars in Belton. Figuring out what's wrong with your vehicle has a lot of similarities to figuring out what's wrong with someone who is ill. Vehicles are a mass of complex systems that can produce a variety of symptoms when something goes wrong. As with human diagnoses, a specific symptom may be indicative of a number of problems, and figuring out the specific cause takes training and experience.
Sometimes the diagnosis of your vehicle's trouble comes down to a matter of trial-and-error. This can be frustrating for Belton drivers because time and money are on the line. You may feel you should only be paying for repair work. Of course, you only want to pay for the right repair – and a proper diagnosis is part of getting it right. Like at the doctor's office — some of what you pay for is the doctor's time and effort to figure out what's wrong with you, not for the actual cure.
The good news is that Belton drivers can do a lot to help out their friendly and knowledgeable service advisors at Jones Automotive in figuring out what's wrong with their vehicle. Again, the medical office is a good analogy. The more information you can give your doctor about where it hurts, when it hurts and how it hurts, the more quickly he will be able to help you. In the same way, the more you can tell your Jones Automotive service technician about when the problem occurs, what is sounds like, how often it occurs, where it occurs, etc., the more efficiently he will be able to get you back on the road.
Good preventive maintenance goes a long way to keeping your car out of a Belton repair shop, but if you need to get it , good communication will get you back on the road quickly.